jasonshiffler

Comments

  • I'm in the same boat, I know how to show the config in Ironport but I can't get NCM to pull it. I used the same command you did in your script. I'm on NCM 5.1 but am thinking it may have something to do with the interactive keyboard issue mentioned above. (I'm using SSH)
    in Ironport template? Comment by jasonshiffler March 2009
  • I've got an Ironport and have the same requirement to download the config. I use SSH2 though. showconfig is the "show run" equivilent in Ironport. After you type showconfig it asks you if you want the passwords included. For a restore to work correctly you need the passwords so you want to respond with a Y. Here's what it…
    in Ironport template? Comment by jasonshiffler March 2009
  • You are right on the money. Thanks for the help.
    in Cisco ASA 5510 Comment by jasonshiffler March 2009
  • I have the same problem and am using TACACS+ to authenticate users. When you SSH into an ASA the enable command doesn't work. (Opened a ticket with Cisco, running 8.0(4). In order to get into enable mode I have to login as a local user. Any ideas?
    in Cisco ASA 5510 Comment by jasonshiffler March 2009
  • Here's a link on Cisco's website that talks about getting PRI utilization information. http://www.cisco.com/en/US/tech/tk648/tk362/technologies_tech_note09186a00801abe59.shtml#topic1 The gateway signaling protocol(H.323,MGCP,SIP) doesn't matter. The info that gets pulled from the lines up with what you see in a sh voice…
    in Need to monitor MGCP PRI GW usage on cisco voice Gateway Comment by jasonshiffler February 2009
Avatar