guran84 ✭✭✭✭✭

Comments

  • This needs to happen! Just finished troubleshooting an issue involving the DirectAccess NLS service we have on our F5:s, the cert was expired.
    in F5 SSL certificate expiration Comment by guran84 October 2019
  • I've changed the reset trigger to the recommended and that worked out nice! Also I changed the config file so that Orion wont remove missing APs. This worked out pretty good, we have all AP alerts in the active list as long as they are active. And we are now able to configure escalation if needed. But it I still want to…
    in Alert on Wireless Access points that goes Down/Missing Comment by guran84 February 2016
  • Hello! I am working with andreasstenlund99 on this. The Alert Trigger Rule is configured like this: And then for Reset Condition: Yet, Alerts is sent as specified in Alert trigger actions, the active alert is in the alert list. But only until next poll when AP is removed completely from Solarwinds NPM. Would the solution…
    in Alert on Wireless Access points that goes Down/Missing Comment by guran84 February 2016
  • Totally and utterly agree! If this is done right, NPM will be hard to beat. This has been our biggest wish since we started using NPM.
    in What We're Working on for NPM (Updated August 10, 2020) Comment by guran84 February 2019
  • I am also experiencing this. I've tried both using IP-address and FQDN. What i have noticed is that it almost always seem to get stuck if i perform any input, like moving the mouse pointer or keyboard press, after clicking "Connect" it gets stucked on either connecting... or reading data... if not making any input at all,…
    in Network Atlas just says connecting and never opens Comment by guran84 April 2017
  • I would agree to all the above.. We use all Cisco Wireless and had issues with the alerting on thin APs. It needs to manage that an AP can move between controllers without causing a down AP, and another with the same name that shows as UP. Some sites have dual HA-Pairs of 5508 Controllers and sometimes APs are moved (we…
    in Your Thoughts on Thin AP Alerting? Comment by guran84 January 2019
  • I also hade issues with this. When implementing both an alert and reset action, i tested the payload text gradually until i was satisfied with the result. All worked OK, both alert and reset actions posted to our Slack channel. After a while i noticed only reset messages showing up on our slack channel. After a bit of…
    in HTTP POST ACTION fails to execute. Any ideas? Comment by guran84 December 2018
Avatar