chipsch

Just posted to spread the word.

Perfect! Thanks DanielleH!

Really like these missions, on a side note though the progress bar isn't showing up in my profile under the missions tab.

Bumping this. Support for XenServer would be a huge value add for us. We are adding roughly 20-30 XenServers yearly right now and it is getting frustrating that we can't get the same insight into these hypervisors as Hyper-V and VmWare.

Well I found the problem. When I created the trusted host entry on the polling engine I did it by domain name. Apparently it needs to be done by ip address for SAM to work. /Facepalm. Thank you everyone for all of the help getting this working.

So I tested the script you provided and it runs correctly from the polling engine itself but not from the SAM application itself. Is there any winrm output I can provide you with? I did also redo the credentials to make sure that they were correct.

This is from the polling engine itself run against the remote host I have been testing against: The output appears all in one line, excuse the fact that it was cut off on the right also please.

I actually read a post before hand where you mentioned the 64 bit portion. I have tried it on both but have kept it on x64 because it did fail on 32 bit. I have also adjusted the write-host with the message syntax and still get "Output Not Defined". Script run fines as a .ps1 on the polling engine where SAM is installed…

Thanks I was just running into this issue as well. Was able to add the UnDP graph to the summary page though. Is there anyway to add multiple graphs to a view for a UnDP?

I have to second this especially since Cisco has released EIGRP to the IETF.

Thank you for the response Alterego. I have made some modifications since I posted and this is what I have now. It runs successfully from the local server when using the invoke-command. I have also verified that I am running winrm 2 and powershell 2. The polling engine itself is a Server 2008 R2 SP1 server. This is what…

I already had a case open for a smaller issue within appinsight so I appended the link to this thread when I uploaded the diagnostics. Case#590465

Before we had an usb audio device on the polling engine that was wired to speakers in the operations area which would play the text to speech so everyone could hear it loud and clear. I did tinker with the .wav files through the web console but it isn't to appealing to move to after what we have been using. It looks like…

Any updates on your ticket status Andy? I have been instructed to run some hotfixes and an update statement to my db but unfortunately it hasn't helped. Running the diagnostics with all services offline atm to shoot over with my fingers crossed.

Trying to get this to work on 10.5 and can't even get it to show up when trying to add a new resource in a view. Anyone have any clues? Tried pretty much everything I have seen in this thread so far to no avail.

Great alert, thanks for putting it together.

Any ideas out there? I have even tried some straight forward scripts that pull computername that work just fine from the polling engine itself but not through the SAM interface itself.

It looks like there is an alert enabled by default in alert manager: Alert me when a multicast routing group at node changes it status. I would try to disable that and see if that meets your requirement. The trigger is set to write to the event log.

Are you talking about the dip in traffic at around noon? Have you checked the actual interface or interfaces and seen if this is in fact accurate? You could lower the load-interval on the switchports to get a more accurate reading from the interface also when you manually check the interface. The lowest the load-interval…

Cisco WS-C4948E-E switches are showing up as 4912G switches. I believe this is actually showing up on other members of the newer 4900 series switch family. EOS/EOL FOR CISCO CATALYST 4912G, 2948G, AND 2980G-A SWITCHES [Cisco Catalyst 2900 Series Switches] - Cisco Systems The above is the actual link providing in NCM. To my…