Comments
-
How do I vote?
-
Done
-
OMG! Holy, I THINK I LOVE YOU! ITS WORKING AFTER FIXING THE ABOVE...... If you were in London I would get you pissed! I can't thank you enough.... I'm going to have a drink. THANK YOU!
-
Holy, Thank you again. Really appreciate your diligence and steadfast in getting this resolved - actually better than Solarwinds support :-) Cheers mate.
-
Hi Holy, I have fixed that ...
-
Holy, Thanks again for not giving up ... The Polling Engine doesn't say 100%
-
Going to check now...
-
Holy, I've had a nice of tea and now see things more clearly :-)
-
ha ha, Will have a cup of tea and look at it again... :-)
-
Good morning Holy I don't have the same screen as you...
-
Guys, Just so you know the alert will work with: 1.3.6.1.4.1.17163.1.1.5.2.7 1.3.6.1.4.1.17163.1.1.5.2.6 1.3.6.1.4.1.17163.1.1.5.2.5 1.3.6.1.4.1.17163.1.1.5.2.4 1.3.6.1.4.1.17163.1.1.5.2.3
-
Hi Holy, Any more thoughts? Regards
-
When I run the trigger in test mode I get the following output: However, when I run the trigger in a live environment I get nothing...
-
Holy Here you go...
-
Hello Community, I was going to open a new request, but because the question is directly related to this poller I thought I would ask the question here... So, can someone tell me why this poller won't work on Cisco ASAs? Regards
-
Why is that?
-
Hi Holy, You didn’t add any comments Carlton Patterson Johnson Matthey Network Engineer
-
Hi Holy, Did mean to add a comment?
-
Holy, Do you mean this?
-
Holy, The full OID
-
OK, this is following your instructions And the definition is attached Just one thought, shouldn't the format be TEXT? Regards
-
OK, going to do that now.... standby
-
Hi Holy/Superfly I ran snmpwalk, see below. I have attached the results.
-
Hi Attached is the new Riverbed Trigger Regards
-
Thank you guys so much .....
-
OK, That's working like a dream.. Thank you all very much Really appreciate it... Cheers
-
OK, so far so good. I've got to do a few more checks, just to make sure its not just a fluke :-)
-
Martin, I'm about to check the following: Using Universal Device Poller you have assigned the interface(s) you want to monitor with this poller and have tested it returns a result (this is important, because I found this poller works for physical interfaces, but not sub-interfaces)
-
I managed to import it as per your instructions - Thanks I've also create a trigger with it, see below. Not sure what to do now...
-
Martin, We just have the following:
