akanechan ✭✭

I'm using the following, using 17.15.06 as an example. this will ensure that the new image is installed and committed. sh install summary | i IMG ${SuccessRegEx:IMG\s+C\s+17.15.06.*}

Thanks, @stuartd, yup. I'm aware that the heatmap is a snapshot of the it's taken the signal reading. I just wanted to use that to record where all APs are located in the office buildings. The process of adding the APs to the map was different from the previous WLC, and also after discovery I was only seeing the ip…

OK, so I can either run discovery from WLC or manage AP as nodes, once added as nodes I can use them in the heat map. Only thing is that since snmp cannot be used for APs and icmp only it just gets ip addresses so I had to update the node details manually.

turns out, i did ask the same question in the past, apologies, just came back from being away due to illness and forgot that I asked question before! Anyway, after running SMNPwalk, the relevant OIDs are missing, so I'd have to hope that Cisco would add them in the future release.

OK, so it seems I can create a rule from Log Viewer. My understanding is "%FTD-3-418018" is an event data, rather than event ID, so I'd select If Event Data contain "%FTD-3-418018" then with "AND" with either "Down" or "Up" conditions? However, I don't understand what subfield is here? Do I just enter something meaningful…