Comments
-
I'm having the same issue as you are and we have been in contact with Cisco support about this and it looks like if you have UCS manager in place you can monitor C-Series servers as long as you have the supported 10GB VIC cards, there is no way to add it into UCS Manager without them. Also as of December and C-Series…
-
Here is the current Url to the updated MIB's for this device. ftp://ftp.cisco.com/pub/mibs/supportlists/ucs/ucs-C-supportlist.html#MIBs_Supported_for_Cisco_UCS_Cseries_20 I've also imported the latest MIB's from solarwinds and also walked the device and found over few hundred items. After you log into the portal down on…
-
I got the same error message. I guess Hotfix 3 is no good!!!
-
I have posted the same question but the end result is that Cisco removed the OIDS that are for the Hardware health after UCS firmware 2.3 and above. They want you to use there product to monitor the hardware health from that product.
-
Have you had any luck with this?
-
I just came back from the Loop1 training in Austin, TX. It was well worth it. The trainer was Andy McBride and you can look him up inside Thwack.
-
Go to Manage Application Monitor Templates and search for (Disk) and should be top of list called Disk I/O.
-
I'm in the same boat. Alerts are going crazy with information that no one can understand. I have applied the NPM 11.5 Hotfix 2, SAM 6.2 Hotfix 1 and NTA 4.1 Hotfix 1 and still have problems. I've been asked to look elsewhere too.
-
Don't do it. Wait till they resolve the issues with 11.5. I found that out the hard way.
-
Have you had any luck with this?