GGray

Comments

  • Marcelo, The IP SLA stats are collected and stored by the device performing the IP Operation at a rate designated by the frequency line in the device config. 'NPM IP SLA' then retrieves these from the device via SNMP at a rate designated by the frequency setting in NPM. Here is an example of one of my IP SLA Operation…
    in IP SLA Latency value red Comment by GGray July 2010
  • I now have a resolution to this issue after raising a ticket. It was basically due to a mis-understanding on my part. I was thinking that the threshold value in NPM was controlling the warning state when in fact it is the threshold value configured on the Cisco switch. Here is the explanation from Solarwinds support: The…
    in IP SLA Latency value red Comment by GGray April 2010
  • Hi Craig, See attached screenshots of one of our IP SLA HTTP Ops. It constantly goes into Warning state even though the threshold is set to 5000. It looks as though it is warning at 1000. Garrie
    in IP SLA Latency value red Comment by GGray April 2010
  • Was there a solution to this problem? I'm getting the same thing. ie. IP SLA HTTP operation continually 'warning' even though thresholds are set way above actual results.
    in IP SLA Latency value red Comment by GGray April 2010
Avatar