ClintW

Comments

  • I really like the idea! Best I've heard in a long while. Are you also recommending a radio button to overlay NCM device configuration change dates/times within the graph? Maybe a "c" icon or similar could be used. I recognize that others (like me) don't use real-time change detection but it could act as notice when looking…
    in Major change bubbles on charts Comment by ClintW February 2013
  • The interface information can be (or is if you perform inventory) pulled by NCM. If the NCM and NPM databases were combined all that information would be in one spot and each module could leverage information without performing the same task twice. I'm quite sure others know this detail above but I thought it should at…
    in Auto pull subnets from route table Comment by ClintW January 2013
  • This needs more votes! Maybe you can get your co-workers at Loop1 like BillFitz to help vote this up. ;-)
    in Copy Rules and Policies Comment by ClintW June 2013
  • Kudos! Best, well written, resume I've seen in a long time too. ;-) Carpal tunnel be damned, you made very valid points of discussion.
    in SNMP Trap & Syslog Rules Overhaul Comment by ClintW May 2013
  • Option #2 sounds the better option to me. I am trying to figure out if I'm between a rock and a hard place. I just purchased IPAM this week with a license level based on what I thought would cover our range of used IP addresses sufficiently with room to grow. My trial setup was fractional for testing which had some of our…
    in Change in IPAM licensing Comment by ClintW November 2012
  • Punk, Can you please post the support case #? I'll then open another support case and reference your info. It might float up the stack of bugs that get fixed sooner. Thanks, Clint
    in Custom report - Unused ports in XX days OR never, admin/oper status Comment by ClintW July 2012
  • "catwsC2960C8pcL" "1.3.6.1.4.1.9.1.1366" "catwsC2960C12pcL" "1.3.6.1.4.1.9.1.1367" Thanks!
    in Tell us your "Unknown" devices! Comment by ClintW July 2012
Avatar