irishjd · Intelligence Specialist · ✭✭✭✭✭

Comments

  • Hi Victor, When I went from NPM 10.6 to 10.7, it was simply an in-place upgrade. If I remember correctly, it was a smooth upgrade too, with no issues. Jon
    in SW npm 10.6 upgrade to 10.7 ?? Comment by irishjd June 2014
  • If anyone is interested, I asked the engineer I was working with on another issue and he gave me the proper syntax for the sql query: Select top 1000 * from dbo.nodesettings Where SettingName = 'ROSNMPCredentialID' AND SettingValue = 'xx'
    in SNMPv3 Credential Management Comment by irishjd September 2016
  • Well, there is just no cure for a short between the seat and the keyboard! They all do have IP addresses, I just couldn't see them via the WLC page. When I went into the Prime page, I was able to get a list of them all, including their IP addresses. As far as the AP's being reported as rogue, is there a way to go into the…
    in Adding Cisco AP's to NPM Comment by irishjd March 2015
  • Just found the solution. I have installed 11.0 RC and the IPv6 Calculator is already installed. Just load Workspace Studio, select Gadgets, select Tools, select Address mAnagement, and then select Subnet Calculator. Jon
    in IPv6 Subnet Calculator Comment by irishjd May 2014
  • I just figured this out. The UDP I imported contained several individual pollers. I thought that I could add the group to the web site, but I just discovered that I have to do it individually by right-clicking on each individual poller.
    in Posting UDP results to the NPM web site Comment by irishjd August 2010
  • Yup, I have a link to the SANS Infocon Status...
    in Additional Website Product Install Comment by irishjd September 2016
  • I too am having this issue.
    in SolarWinds NCM Connector for Cisco SmartAdvisor Comment by irishjd November 2015
  • I would suggest doing some reading on SNMP v3. It is very different from v1 and v2. There is a lot of configuration to do on the clients themselves. At a minimum, you need to configure a SNMP v3 group and user. You also need to assign views to the group/s. Some of the views that I use are: internet, system, interfaces, and…
    in SNMPv3 Configuration in NPM Comment by irishjd April 2011
  • I have had a TAC open with Cisco on this issue for awhile now. Their stand is that there is nothing wrong on their end and everything is functioning properly. If you don't want to disable all Hardware Health monitoring on the switches generating these alerts, they suggested adding the following IOS commands to those…
    in 10.4 hardware health monitoring - anybody know what a bias current sensor is? Comment by irishjd December 2012
  • Just found it.
    in New NTA Feature Comment by irishjd January 2010
  • Bummer, it didn't post the actual data I used. The description is Multicast, and the beginning of the range is 224.0.0.0 while the ending of the range is 239.255.255.255.
    in Multicast Address Usage Comment by irishjd October 2012
Avatar