I also get the error that Netflow hasn't been configured for this device when clicking on it in NTA. I enabled netflow on the device's interface, but no luck.
1 of 1 people found this helpful
Have you set the source interface that Netflow will send packets from? ie:
ip flow-export source <ip address>
The IP address you give as the source interface should be the same as what you're managing the device with in Orion. Preferably a loopback?
Thanks Craig. I actually just figured it out about 10 minutes before you replied. I hadn't set the destination to Orion... I figured since NTM could see the device, it was config'd correctly on the router.
Edit: For anyone that's trying to configure netflow on Cisco devices, this link is helpful: