7 Replies Latest reply on Jul 3, 2015 7:15 AM by hotstuff64

    Problem with Cisco SG500 Backup

    hotstuff64

      My problem with Backup the config of the Cisco SG500 is, that I got the error message "Did not receive expected prompt after disable command".

      The config was saved but I couldn't solve the error.

      I think that they try to open the Enable-Mode, but the SG500 haven't.

      I config the "Variations" to Backup the devices but I didn't find where I can disable the "Enable-Mode" calling.

       

      Error SG500.jpg

       

      Any ideas where my mistake is?