Guys,
Can anyone advise me on how NPM 11 can monitor the true value of an ADSL ATM interface such as on a Cisco 877 router you would gleen show dsl atm int atm0 and the following info would appear:
linkwood_r877#sh dsl int atm0
ATM0
Interleave Fast Interleave Fast
Speed (kbps): 8064 0 448 0
Cells: 259671817 0 1876261723 0
Reed-Solomon EC: 39 0 29 0
CRC Errors: 25 0 4 0
Header Errors: 28 0 2 0
Total BER: 7660E-12 0E-0
Leakage Average BER: 1175E-41 0E-0
ATU-R (DS) ATU-C (US)
Bitswap: enabled enabled
Bitswap success: 0 0
Bitswap failure: 0 0
But Solarwinds reports on the physical interface such as:
linkwood_r877#sh int atm0
ATM0 is up, line protocol is up
Hardware is MPC ATMSAR (with Alcatel ADSL Module)
MTU 4470 bytes, sub MTU 4470, BW 448 Kbit/sec, DLY 820 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ATM, loopback not set
So when monitoring the interfaces it shows that the ATM interface is more than 80% utilized but technically it's not.
Has anyone figured out a way so that Solarwinds will report on the true DSL speeds?
Thanks