4 Replies Latest reply on Mar 31, 2015 11:23 AM by dan.daenzer

Thresholds not working

dan.daenzer Mar 27, 2015 1:00 PM

Hey guys and gals, I am having an issue getting my proxy servers to report memory utilization. I am using the BluecoatMemoryUsage custom poller with the warning set at 70% and critical at 90%.

To test reporting I set the warning threshold to 10% and the status dot stays green even though the proxy mem usage is about 40%.

Can someone please explain like I'm 5 what I need to check.

I DID make sure the OID was good and tested it from the server and it checks good.

thanks for any assistance.

dan

Re: Thresholds not working

017hnoor Mar 31, 2015 6:59 AM (in response to dan.daenzer)

To test reporting I set the warning threshold to 10% and the status dot stays green even though the proxy mem usage is about 40%.

_________________
NOOR
Like Show 0 Likes(0)

Actions
Re: Thresholds not working

mrs.alterego Mar 31, 2015 9:23 AM (in response to dan.daenzer)

dan.daenzer - I've moved this into Network Performance Monitor forum because I believe this might fit that product a little better and give you some more eyes on your question. :-)
Like Show 0 Likes(0)

Actions
Re: Thresholds not working

rob.hock Mar 31, 2015 10:50 AM (in response to dan.daenzer)

UnDP threshold breech does not affect node status directly, but can be visualized in other ways. HolyGuacamole gives a good run down of options here:Custom Poller Thresholds doesn't affect node status
New in 11.5 is a Alert Action that allows you to manually set Node Status. This could also be a good option.
Like Show 0 Likes(0)

Actions
- Re: Thresholds not working
  
  dan.daenzer Mar 31, 2015 11:23 AM (in response to rob.hock)
  
  Thanks Rob. I will check that out. Appreciate the time.
  
  Like Show 0 Likes(0)
  
  Actions

Go to original post