2 Replies Latest reply on Mar 12, 2015 2:56 AM by mike558

    What do I need to do to get the LAN base template loaded?

    mike558

      Hello all, I have a switch on a remote site that I need to act as a router. The switch is a cisco WS-C2960S-24TS-S.I understand that in order to do this, the switch needs to have the LANbase SDM. This is my current setup:

       

      SW01#sh sdm prefer
      The current template is "default" template.
      The selected template optimizes the resources in
      the switch to support this level of features for
      0 routed interfaces and 255 VLANs.

      number of unicast mac addresses: 8K
      number of IPv4 IGMP groups: 0.25K
      number of IPv6 multicast groups: 0.25K
      number of IPv4/MAC qos aces: 0.375k
      number of IPv4/MAC security aces: 0.375k
      number of IPv6 policy based routing aces:         0
      number of IPv6 qos aces: 0
      number of IPv6 security aces: 0.125k

       

      What do I need to do to get the LAN base template loaded?

      Do I need to upgrade the ios? If so, do I need to purchase a Smartnet in order to download this?

      Any help is greatly appreciated!

      Cheers