This discussion has been locked. The information referenced herein may be inaccurate due to age, software updates, or external references.
You can no longer post new replies to this discussion. If you have a similar question you can start a new discussion in this forum.

Issue with adding Cisco routers even with complete SNMP config

Hi Guys,

Please I just want to ask if anyone has observed that sometimes even with correct SNMP configurations on Cisco routers, adding a node on NPM can be an issue.

This is my observation. On two occasions, I have tried to add a node (Cisco 819 router, running on a SIM) but at the point of testing to see if the node is reachable, the test fails, even with correct set parameters.

Any ideas?

Regards,

David Ibrahim.