This discussion has been locked. The information referenced herein may be inaccurate due to age, software updates, or external references.
You can no longer post new replies to this discussion. If you have a similar question you can start a new discussion in this forum.

Netflow configuration on Cisco 3850

Hey Everyone,

I have been setting up a new installation of NTA and ran into an issue last night while trying to configure net flow on a stack of Cisco 3850s.

I have been following this article.

NetFlow on Cisco Switches: NetFlow v9 configuration for Cisco Catalyst 3850

Everything works fine until i try to apply it to the interface to be monitored.  The ip flow monitor command is not an option.

I have NetFlow running on my 6500s and ASR routers but this has been stumping me for a few hours.  Any suggestions?

Thanks,

B