This discussion has been locked. The information referenced herein may be inaccurate due to age, software updates, or external references.
You can no longer post new replies to this discussion. If you have a similar question you can start a new discussion in this forum.

NPM 10.7 and Enterasys

I am wondering if anyone has run into any issues with polling/monitoring Enterasys network devices.

New install of Solarwinds, new DB, all on W2012R2

I am working on discovering a network with N series, K series and S series devices.

The discovery, for the most part, times out.  I have extended the discovery times, and lowered the

device count to a few at a time.

Sometimes the discovery times out and there are no other options, sometimes the discover times out

and I can see a chassis was found, but no interfaces.  Other times, there is a timeout, and of the 10 devices

5 are just chassis info, and 5 have interfaces.

   I ran an SNMP walk on one of the S8 chassis and the Walk failed after 30million OID's were found (seems a bit high)

On the other hand, when I run the discovery of the device in the Engineer toolset NPM, no issues.

The Server and DB are fine, oversized, and error free. 

All being done with SNMPv3

Can take 30+minutes just on a list resources

Thanks in advance