0 Replies Latest reply on Apr 16, 2014 3:06 PM by aaron.damyen

    Need help monitoring Solaris zone interfaces

    aaron.damyen

      How do I setup Solaris zone nodes in NPM to properly identify the interfaces through a reboot?

       

      The interface names reported for a Solaris zone can change when the zone is rebooted. Unfortunately, this causes the old interfaces to go into a 'unknown' status and the new interfaces are not being shown on the details page.  Is there a mechanism/option I need to enable to allow the interfaces to change names without dropping monitoring?

       

      Is there a component for Virtualization that I should be using which will appropriately remap the interfaces when it notices a change?