2 Replies Latest reply on Nov 25, 2013 12:08 PM by dstjames

    CBQOS config question

    dstjames

      We have a couple of applications that we want to prioritize over other traffic. We also have limited bandwidth at our end locations and have noticed that when someone downloads their entire exchange mailbox it takes up a lot of bandwidth slowing everything down so we want to limit that. I would like to setup cbqos to monitor that the critical traffic is being shaped correctly but I get no cbqos feeds. I am sure its something I have configured incorrectly. When I look in solar winds I get netflow fine from this device but says last received cbqos is never. When I run a sh policy-map int multi1 I see that it is catching packets so I think qos is working. Any help you can give is appreciated.

       

      Here are the relevant sections of the config. 

       

       

      access-list 101 permit tcp any host 192.168.0.231

      access-list 101 permit tcp any host 192.168.0.238

      access-list 102 permit tcp any host 192.168.0.112

      access-list 102 permit tcp any host 192.168.0.204

       

      class-map match-all EXCHANGE

      match access-group 101

      class-map match-all CRITICAL_APPS

      match access-group 102

      policy-map QOS_POLICY

      class CRITICAL_APPS

        set dscp af23

      class EXCHANGE

        set dscp af11

        shape peak 500000

       

      interface Multilink1

      description Bonded MPLS 3.0mb

      ip address x.x.x.x 255.255.255.252

      ip flow ingress

      ip flow egress

      ppp multilink

      ppp multilink group 1

      service-policy output QOS_POLICY

       

      snmp-server ifindex persist

      snmp-server enable traps entity-sensor threshold

      snmp mib persist cbqos