1 Reply Latest reply on Jul 30, 2013 3:04 PM by Bahlkris

    Nodes in Warning Status

    rhether

      Our default node warning level is set to 120 seconds.

      After this period the node goes into down status.

      For nodes that do not go into down status (less than 120 seconds), is there a way to get the length of time that the node was in warning status ?

        • Re: Nodes in Warning Status
          Bahlkris

          Since its polling based I would say no, or at least not without decreasing the polling interval.  Even then there is going to be room for error.  Depending on the device you could probably mitigate this with logging/syslog/trap but it would be relative to the nature of the problem.

          1 of 1 people found this helpful