NPM 10.5 - firewall not showing routing information

Can you check if routing pollers were assigned to your Cisco ASA - run List Resources, Routing pollers should be selected.

Jiri

Hi Jiri

I have checked and the router poller is assigned.

Thanks

Richard

Do you have some rows in NPM_Routing and NPM_RoutingTable tables in database for specific NodeID?

I've checked and the picture below is the result of the NPM_Routing table and there are no entries in the NPM_RoutingTables table for the NodeID in question.

Are you able to get some values from ipRouteTable (1.3.6.1.2.1.4.21)? You can use UnDP or Toolset, if installed.

If this works for you (you see the data), please open a support ticket and place the number here.

Thanks,

Jiri

Hi Jiri

I do not get any response from the firewall on this OID on the firewall.

I've also tried this OID on a switch that has routing table entries in NPM and I do not get any response on that either, despite it showing the routing tables in NPM/

Thanks

Richard

1.3.6.1.2.1.4.21 is OID for ipRouteTable. You have to spefify which value (I mean column)  are you looking for, e.g. 1.3.6.1.2.1.4.21.1.1 for ipRouteDest.

I tried 1.3.6.1.2.1.4.21.1.1 and get nothing on the firewall or a NPM working Cisco switch.

I tried an snmpwalk from 1.3.6.1.2.1.4.21 too which should show everything below it and also nothing.

I know the snmp is working as I can get a response from a walk to 1.3.6.1.2.1.4 ok.

Maybe Cisco do not support this OID? Does NPM use a different OID to poll for Cisco kit?

Please, try this one on Cisco ASA 1.3.6.1.2.1.4.24.4.1.1.

That one didnt work on the ASA, no results

But it did work on the Switch that is working in NPM for routing tables.