5 Replies Latest reply on Nov 22, 2012 1:44 AM by thamizh85

    How to configure Universal Device Pollers alert to indicate the row triggering an alert

    thamizh85

      From the release notes of Orion 10.3 I find this should be achievable.

       

      http://www.solarwinds.com/documentation/orion/docs/releasenotes/RNArchive%5CreleaseNotes_10_3.htm

       

      But so far I haven't figured out how. We have configured temperature monitoring for our Cisco 6500 chassis which responds with a table of temperature values. Now when we configure alert based on the violation, we get only the top row value in our email alert whereas we want to get the row which is triggering the alert.

       

      Here is the alert message we are using:

       

      Network Node ${NodeName} environment temperature value was ${CustomPollerStatus.Status} degree celcius at ${DateTime}