1 Reply Latest reply on Oct 2, 2012 7:18 PM by sirpaw

    NetFlow x 3Com 4800G

    maschimidt

      Hello
      I have a 4800G on my network in which ja I enabled sFlow on an interface specifies the config as shown below

        sFlow Agent ip 192.168.0.254 <- My core switch
        sFlow collector ip 192.168.1.4 <- My SolarWinds NetFlow
        sFlow interval 60


      interface GigabitEthernet2/0/7
        description UTI_Visitantes
        port link-type hybrid
        port hybrid vlan 10 20 50 60 tagged
        port hybrid vlan 1 untagged
        speed 1000
        full duplex
        sFlow enable inbound
        sFlow enable outbound
        sFlow sampling-rate 100,000

      When I click on the interface configured in the NetFlow I get the following message:

      Details for interface 'GigabitEthernet2/0/7' on 'CSW.GTI.01.254' are not available because CBQoS and NetFlow data are not available.

      Refer to device vendor's documentation to enable these features.

      What is NetFlow? What is CBQoS?

      Anyone have any idea where I am going wrong?

        • Re: NetFlow x 3Com 4800G
          sirpaw

          Hi,

           

          There might be a reason why netflow data is not being collected. As was suggested in the interface details, perhaps you should recheck your configuration and check if there is actual data or any similar represetation on the device CLI in order to know the agent is generating netflow/sflow data. Also, the netflow port may not be permitted in between SolarWinds and the netflow agent. I don't know if its the same with 3COM/sflow, but with Cisco Netflow its 1055.

           

           

           

          Regards,

          Paulo