I looked at many older posts on the Thwack community forums, but each one was unanswered regarding sFlow. I'm trying to figure out if the current version of NTA supports sFlow analysis.
Thanks,
-bobby
Top Replies
-
Bobby, Yes. NTA has had SFLOW support since version 3.6 or 3.7 I believe. Regards, Matthew Harvey Loop1 Systems -
It sure does. Check out the product page. It's part of the description. http://www.solarwinds.com/netflow-traffic-analyzer/system-requirements.aspx Analyzes Cisco NetFlow, Juniper J-Flow, IPFIX, sFlow…
-
-
It sure does. Check out the product page. It's part of the description.
http://www.solarwinds.com/netflow-traffic-analyzer/system-requirements.aspx
Analyzes Cisco
NetFlow, Juniper J-Flow, IPFIX, sFlow, Huawei NetStream
& other flow data 
-
I see
I'm a bit of a Orion boon 1st day on the job, heh.Thank you Richard, and Matthew!
-
No worries. I was there one time too.
I'm just glad this community is as active as it is. One of the best user groups for a product I have been apart of. 