4 Replies Latest reply on Aug 24, 2011 1:01 PM by bshopp

    How monitor traffic interface down protocol?

    scrpn

      Hi all.

      My Orion NPM 10.0 can not monitor traffic interface router Huawei is down protocol. ex router Huawei Ne40e, interface assign vlan run mpls l2vpn, don't assign IP address.

      But when i restart server, NPM can monitor traffic in first new minutes, and then is not monitor. How can i fix it to monitor traffic?

      Thanks!

        • Re: How monitor traffic interface down protocol?
          scrpn

          I fiound in Orion quick start guide have:

          Note: After installing Orion NPM, the polling engines create a baseline by
          collecting status and statistics immediately, and then collecting them again 30
          seconds later. You may notice an increase in your CPU usage during this time.
          After this initial collection, Orion NPM collects network data every 10 minutes for
          nodes, every 9 minutes for interfaces, and every 15 minutes for volumes. 

          Because After installing Orion NPM, the polling engines create a baseline by
          collecting status and statistics immediately, and then collecting them again 30
          seconds later
          --> NPM can monitor traffic interface that down protocol.
          But then every 9 minutes for interfaces, the polling engines do not collec in the Interface is DOWN.
          Anyone have fix?