Temperature Gauge Catalyst 2950

Question

I created a gauge to view the temperature on my Catalyst 2950. I am using a support MIB/OID on it so I know that's good and it did pass

the MIB test. But It's not display the temperature on the gauge. It shows the guage but at the bottom it says "EnableTemperatureNo".

Anyone have any ideas on why this might be happening?

tlwoodstx · Accepted Answer

Inside Universal Device Polller if you go to assign a MIB, you can test it against a specific device before completing the assignment. In the case of the 2950 when you use the default example for Cisco temperature, the test returns the results of OID not supported.