2 Replies Latest reply on Jan 20, 2011 3:36 PM by tjbradford

    Cisco 6509 - Configure Netflow

      Hi All,

      We have Cisco Netflow enabled on 2 1G WAN Interfaces on the Cisco 6509. But the problem is we dont see all the data being captured in the netflow. Because we see the link is utilized like 50M/sec but the statistics capture is very very low. Below is what we have configured in our Cisco 6509.


      mls flow ip full
      mls nde sender version 5
      ip flow-export source Loopback0
      ip flow-export version 5
      ip flow-export destination 10.88.69.10 2055

      interface GigabitEthernet5/1
       ip address 10.88.87.1 255.255.255.0
       no ip redirects
       ip flow ingress
       ip pim sparse-mode
       spanning-tree portfast
      end

      interface GigabitEthernet6/1
       ip address 10.88.88.1 255.255.255.0
       no ip redirects
       ip flow ingress
       ip pim sparse-mode
       hold-queue 2000 in
      end


      Also in our Solarwinds Orion i am receiving flow from all our VLAN's including the 2 WAN ports we enabled them for. Did we configure anything wrong? And we are seeing the CAM tables are full.

      Thanks