4 Replies Latest reply on Nov 5, 2010 1:53 AM by AlexSl

    Status PSU for devices with two PSU

    AlexSl

      On the Cisco 7606 installed 2 power supply unit.
      Can I using Universal Poller obtain information about primary and secondary power supply unit?
      With SNMP Get (MIB OID 1.3.6.1.4.1.9.9.13.1.5.1.3, name ciscoEnvMonSupplyState) I get information about state only one PSU - primary or secondary

        • Re: Status PSU for devices with two PSU
          lchance

          That particular model does not support the CISCO-STACK-MIB mib which does provide identifying information from the OID for Primary & Secondary.

           

          Although this Cisco 7206 shows both power supplies, I can alert if either fails, however I can't tell which is primary and which is secondary. I think you could do the same with alerts.

            • Re: Status PSU for devices with two PSU
              AlexSl

              To Ichance

              I can generate a different Alert for the first and second PSU using Row ID
              I can not draw the first and second PSU state in the web page (((( 

              I looked CiscoStackMIB
              Can use:
              chassisPs1TestResult 1.3.6.1.4.1.9.5.1.2.5
              chassisPs2TestResult 1.3.6.1.4.1.9.5.1.2.8

              But!!!((((

              MIB is supported by Cisco7600, but is not supported on Cisco4500 (((

            • Re: Status PSU for devices with two PSU
              slake

              I use 1.3.6.1.4.1.9.9.13.1.5.1.3 for the first power supply, and 1.3.6.1.4.1.9.9.13.1.5.1.3.2 for the second power supply. We are in load sharing mode. Seems to work. I haven't turned one off to test though.

              1.3.6.1.4.1.9.9.13.1.5.1.3   Mib Value=RAW, Format=none,  SNMP Get type=Get Next

              1.3.6.1.4.1.9.9.13.1.5.1.3.2 Mib Value=RAW, Format=none,  SNMP Get type=Get

              I think the second has to be Get only because it's pulling from a table.