0 Replies Latest reply on Sep 29, 2010 1:01 PM by bpaine

    Trap alert supression?

    bpaine

      I have a device which I want to monitor a trap on.  (Analog trunk goes down  vertical.0.86) but I want to be able to supress that if I see the analog port come back up within a few minutes (vertical.0.87)

       

      This system doesn't send traps unless it's a actual state change so I can use the supression based on traps over time.  Is there anyway to make a trap supression (without polling... I have hundreds of these phone systems) but only have the alert triggered if it isn't followed by a trunk up OID in a couple minutes?