3 Replies Latest reply on May 15, 2010 10:32 AM by jdaugherty

    Circuit speed vs link speed config

    lostinvt

      This is driving me nuts, and I found some similar questions in the forums, but nothing that worked for me...

      I've just brought up a new office.  It's connected to my MPLS via ethernet, so the router has a full gig link to my carrier, but at present the port speed is limited to 12 megs.

      NPM is happily telling me that I'm using less than 1% of my circuit for anything under almost a full saturation....

      So how can I tell NPM that the circuit is only 12 megs? I couldnt seem to figure out how to edit the bandwidth speeds in system manager, they are greyed out....