2 Replies Latest reply on May 14, 2010 12:01 PM by RyanJett

    Wrong info in Help about mapping vlans in Engineers Edition

    kindbro

      I recently looked up how to use switch port mapper on a particular VLAN. When I was reading through the help info of the Engineers Edition 10.5.0.79 it showed this

      "Note: If you want to map a device with VLANs configured, specify the  community string in the following format: communityString@VLAN#. For example,  to scan VLAN 2 using the public community string, type public@VLAN2"

      Unfortunately, using the above example did not work. So after a few minutes of trying to get it to work I tried doing it as example public@2 and it worked. Figured you would want to update the help info.

       

      Thanks,

      Bret