2 Replies Latest reply on Apr 7, 2010 9:13 AM by polia

    bandwidth graph question

    polia

      Is it possible to fix the Y axis on percent utilization graphs to be set so where it always indicates the available bandwidth of the measured interface?  For example, we have an interface with a bandwidth availability of 25Mb however if we have used only 20 Mb the Y axis on the graph will only measure against that amount, rather than the full 25.  We run reports that show utilization for the week that are sent to management and they want to see the full amount.  I've explained that it is listed at the top of the chart but they want to see the it on the Y axis also (see image below).  Is this possible?

      thanks

      Anthony