I'm having difficulty getting output from the switch port mapper command line tool SWSPMCMD.exe. When I run the tool I recieve this output. Any insight would be greatly appreciated.
SolarWinds SwitchPortMapper Command Line Version 10.0.0.237
(c)Copyright SolarWinds 2009 All rights reserved.
Layer 2: Testing credential...
Layer 2: Getting sysObjectID...
Layer 2: Getting sysUptime...
Layer 2: Getting VLAN membership table...
Layer 2: Getting dot1q Bridge-MIB
Layer 2: Getting dot1d Bridge-MIB
Layer 2: Device does not support the Bridge-MIB.
*** Unable to collect all the required data to complete the port map.