2 Replies Latest reply on Oct 14, 2009 1:27 PM by c2computer

    IP Monitor v10.0 build 1363 - Cisco MIB/Problems/Cannot Scan Routers with SNMP

      Is anyone else running 10 and having these issues?  We upgraded to take advantage of the unlimited licensing but a lot of our monitors went dead/empty values, etc.  Cannot scan routers now and see more than 4-5 monitors when before on 9.01 we had 50 or so (we run Cisco voip so a lot to scan here) on each router.  Appears Cisco MIB's are not being used right.

      Probably need to roll back unless someone at SW can figure this out by the end of the week.  If anyone has any suggestions I am all ears.  Thanks