Custom alarm

Question

I just got NPM setup. I have several sites with a T-1 that have a CIR of 1 meg. The normal alerts wont trigger since the they are based on the interface's rate of 1.54.

How would I create an alarm for those devices that will trigger at 75% and 90% of 1 meg.

Scottyaz · Accepted Answer

OK, I realized I was looking at the wrong part of the directions.

I can set a custom alarm to trigger when the TX + RX hits a threashold and if the BW is set to X value.

Then I realized I really want to see this on the interfaces that are at high utilization, not just an alert. I'll do more research on this. Mods, you can knock out this post if you would like.