0 Replies Latest reply on Jun 19, 2009 4:03 PM by hammermedia

    Fixed Scaling on Reports

      When I run a bandwidth utilization report on a switch I need the scale on each of the ports to be the same.

      It's hard to tell where the traffic is moving if I have port 1 on a 0.01 mb/s scale and port 5 on a 60mb/s scale.

      If port 1 and port 5 were on the same scale I could easily see that port 1 had almost no usage (due to the fact it's max bandwidth was less than 0.01 mb/s) and port 5 was busy.

      Is there any option to make it the same for all ports?

      Thanks!

      Tim