1 Reply Latest reply on Nov 4, 2008 6:22 AM by Yann

    Error configuring Netflow on cisco 2610XM/7204VXR router

      I am in the process of configuring Netflow on some of our Cisco devices but when I try to do it on our Cisco 7204 VXR router ,I get the following Error message ‘ The device you specified does not allow the configuring of netflow support, ports, Ingress and egress interfaces’. This error message pops up as well when I try to configure  some of our Cisco 2610 XM routers, I noticed it happens on the routers with revision number 0x200 (Not sure if it has something to do with it). I have listed below my method of configuration  as well as the version of the routers in question

       

       

      Procedure

      Configure snmp-server community string to read-write on router

      Logged on to server hosting Orion engineer tool set and used Netflow configurator tool to configure netflow using my configured snmp string

       Model

      Cisco 7204VXR (NPE225) processor (revision A) with 114688K/16384K bytes of memory.

      Processor board ID 23650690

      R527x CPU at 262Mhz, Implementation 40, Rev 10.0, 2048KB L2 Cache

      4 slot VXR midplane, Version 2.1

      ROM: System Bootstrap, Version 12.2(1r) [dchih 1r], RELEASE SOFTWARE (fc1)

      BOOTLDR: 7200 Software (C7200-BOOT-M), Version 12.0(13)S, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)

        

      Cisco 2610XM (MPC860P) processor (revision 0x200) with 94208K/4096K bytes of memory.

      Processor board ID JAE08030YTR (3194872936)

      M860 processor: part number 5, mask 2

      Channelized E1, Version 1.0.

      Bridging software.

      X.25 software, Version 3.0.0.

      Primary Rate ISDN software, Version 1.1.

      1 FastEthernet/IEEE 802.3 interface(s)

      1 Serial network interface(s)

      1 Channelized E1/PRI port(s)

      32K bytes of non-volatile configuration memory.

      32768K bytes of processor board System flash (Read/Write)

      ROM: System Bootstrap, Version 12.2(8r) [cmong 8r], RELEASE SOFTWARE (fc1)

      ROM: C2600 Software (C2600-ADVIPSERVICESK9-M), Version 12.3(6e), RELEASE SOFTWARE (fc3)

        

      Is there any other way I can configure Netflow on these devices?