2 Replies Latest reply on Aug 12, 2008 3:18 PM by kulastone

Timeouts

japplewhaite Aug 12, 2008 5:35 AM

I am getting a number of warnings and downs on nodes that are not. As a rule no sooner that the device goes down it goes back up. It would seem that it could be a network performance issue but pings do not seem to indicate so. The utilization on interfaces is between 0% and not more then 3% in all cases.

Any suggestions?

Re: Timeouts

mark wiggans Aug 12, 2008 7:09 AM (in response to japplewhaite)

Decrease the polling frequnecy on the nodes in question. What else is ocurring on the DB at this time? Anymore details about the timeouts?
Like Show 0 Likes(0)

Actions
Re: Timeouts

kulastone Aug 12, 2008 3:18 PM (in response to japplewhaite)

I get those too. I get an alert for a CISCO core switch going down but when i run the uptime command, it shows that it never went down. Weird. Goes down and comes back up in the same minute. 2minute polling intervals.
Like Show 0 Likes(0)

Actions

Go to original post