This discussion has been locked. The information referenced herein may be inaccurate due to age, software updates, or external references.

You can no longer post new replies to this discussion. If you have a similar question you can start a new discussion in this forum.

Dell N1500 Series Switches

sdawson35 over 4 years ago

I have done what I believe to be the correct setup, created a login profile and tested good, enabled for config change, can download running and startup but am not getting real time config changes.

I realise I will have to create a custom rule but not sure where to start.

I can see the messages in the traps section of the log viewer

Han-xxxx-xx-1 TRAPMGR[trapTask]: traputil.c(721) 3746618 %% NOTE 'startup-config' has changed.

Han-xxxx-xx-1 CLI_WEB[emWeb]: cmd_logger_api.c(260) 3746616 %% INFO [CLI:xxx:10.xx.xx.xx] Copy file running-config to startup-config

0 neomatrix1217 over 4 years ago

Here are the steps for real-time change detection
Configure real-time change detection in NCM
Cancel
Vote Up 0 Vote Down

Cancel
0 sdawson35 over 4 years ago in reply to neomatrix1217

Does NOT work for Dell hence my posting on here....
Cancel
Vote Up 0 Vote Down

Cancel
0 neomatrix1217 over 4 years ago in reply to sdawson35

Are you using the new Orion log viewer or the legacy?
Cancel
Vote Up 0 Vote Down

Cancel
0 sdawson35 over 4 years ago in reply to neomatrix1217

New Orion log viewer (we are running 2019.4 HF1).
I managed to get it to work briefly and very intermittently using the following custom config. I am not quite sure if I need more or less entries.
Cancel
Vote Up 0 Vote Down

Cancel
0 GoldTipu over 4 years ago

Please see these posts below
NCM troubleshooting landing page
Troubleshooting RealTime RTCN Notification
Troubleshot NCM RealTime Change Notification RTN logs / email issues
I am not receiving Real Time Change Notification emails ? Why ? What to check and which logs ?
Cancel
Vote Up 0 Vote Down

Cancel
0 superfly over 4 years ago in reply to sdawson35

With my custom rules, I'm finding that not all syslogs are looked at. So for example I have a rule that will forward me syslog 0, 1 & 2's. But if a device sends 4 in a minute, I will only receive one of them. I have a ticket raised for this.
The old legacy syslog viewer would forward every single email. I didn't miss a single one.
You could try changing the Source to everything and see how that goes. Or create a single rule for each of your 3 "look for specific entries" section.
Cancel
Vote Up 0 Vote Down

Cancel
0 sdawson35 over 4 years ago in reply to neomatrix1217

new log viewer but its all working now changed logging facility from 4 to 7 and it made a huge difference have 20+ units all working as expected.
Cancel
Vote Up 0 Vote Down

Cancel