2 Replies Latest reply on Nov 18, 2019 12:09 PM by jnreston79

    Cisco ISR 4331 router Node showing MPLS routing IP

    jnreston79

      I added a new ISR 4331 router it connects through an MPLS. So, it is showing the MPLS IP instead of the internal IP address. I was able to configure other routers when I first installed the SEM to use the internal IP. I am unable to find the article I used to make the change. I am hoping someone might know the commands or could help point me in the right direction.

       

      Thanks

      Joe