1 of 1 people found this helpful
It is not clear if you have the time period covered, but this will simply be part of the trigger filter using the 'Last Status Change' value.
Make sure in the Alert Object setting on Trigger tab you select Interface, so that the Interface variables are available to pass to the Execute NCM Action.
Write out your command to shut the interface eg.
Copy run start
This works, thank you Mark!
Yes, that is the beauty of NCM, in that the Execute Script function in the alert is simply a box you can type out the appropriate command syntax for the device you are applying the change to.
Therefore, when you are creating your alert, you may have an alert definition for devices that support Cisco IOS commands within the action of the alert and then a separate alert which will have the syntax for Junos. Each alert will simply need a filter on the Trigger Filter page so that the specific vendors are included only to match the alert action definition.