This discussion has been locked. The information referenced herein may be inaccurate due to age, software updates, or external references.
You can no longer post new replies to this discussion. If you have a similar question you can start a new discussion in this forum.

UnDP Delta For Counters

I'm trying to figure out how to setup my UnDP and Transform for an interface. I can't seem to figure out how to setup the device poller to show me the difference from one poll to the next, I constantly get what the whole counter reads at each poll instead of just the difference. I'm probably setting the interval wrong or something but any combo I try it doesn't seem to work.

Anyone ever get this working? I see a few posts about how a counter poller automatically does this but when I use the counter option on my poller it doesn't give me delta. Any options I seem to set on it give me the entire counter total.

What I need is this:

Current = <CurrentCounterPoll> - <CounterPoll5MinsAgo>

Any ideas?

Parents
  • Hi Joe,

    Ensure that you are at least on NPM 9.5 and above, as there are known issues on Transforming COUNTER OIDs.

    Note that the delta values will not be seen straight on the UnDP Console, but rather... it is seen on the Web Console (if you used Web Display)

    Those values that are being shown in UnDP console are actually RAW values.

    HTH.

  • You are correct the web page does show delta, and I was able to get this working with the poller/transforms I created.

Reply Children
No Data