0 Replies Latest reply on Feb 24, 2018 12:39 PM by peter.reim

    Monitor Access Points from Controller

    peter.reim

      I want to monitor access points from the controller. i can retrieve the values from the table via snmp. to see the values, I created two UnDP (AP name and AP status). The two UnDP access the same table.

      then I created the alert with "Custom Table Poller Current Status"
      this only monitors for status. therefore, I only see the status if the ap is disconnect but not the name of the ap. how can I adjust so that i can also see the name of the ap?