In this interface, is configurate a real bandwith ?
My question is if the bandwith is 1 GB Or 10 GB for it. ?
the port on the ASA is configured as 100Mb. NPM is using that as the bandwidth in the interface details
Can you show a report, please, In the last hours.
not sure what you mean by a report. heres what i can see
Interface GigabitEthernet0/0 "outside", is up, line protocol is up
Hardware is i82574L rev00, BW 1000 Mbps, DLY 10 usec
Full-Duplex(Full-duplex), 100 Mbps(100 Mbps)
Input flow control is unsupported, output flow control is off
402265275974 packets input, 73167337385324 bytes, 0 no buffer
Received 1062924 broadcasts, 0 runts, 0 giants
1 input errors, 1 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 pause input, 0 resume input
0 L2 decode drops
399389450289 packets output, 62188175401179 bytes, 0 underruns
0 pause output, 0 resume output
0 output errors, 0 collisions, 3 interface resets
0 late collisions, 0 deferred
0 input reset drops, 0 output reset drops
input queue (blocks free curr/low): hardware (494/362)
output queue (blocks free curr/low): hardware (511/255)
Traffic Statistics for "outside":
402253971259 packets input, 65915059991388 bytes
399389450289 packets output, 54991885541309 bytes
9006855 packets dropped
1 minute input rate 23188 pkts/sec, 10641373 bytes/sec
1 minute output rate 21416 pkts/sec, 2660618 bytes/sec
You can remove this image, have informations confidentials MAC address and IP address.
You can see in percente utilizations, package per second, average packet size but not show what time are this winformations. If are last 24h hours or 12h hours.
And If Orion have configurate for defaul you can see estatistics for 1000mb/s but if your traffic is 2GB/s show informations error.
Please look this inforamtions about managent interface with NPM
1 of 1 people found this helpful
the ASA is a 1Gb interface but it is configured as 100Mb full duplex.
NPM is using the default setting which seems to pick it up as 100Mb. That seems correct but gives the wrong usage stats.
if i change NPM bandwidth to 1000Mb/s it seems to give the correct value. Is that the answer to the problem?
Thanks for your help
Did you ever fix this issue, i'm facing the same issue?