0 Replies Latest reply on Aug 11, 2017 9:57 AM by alankar.srivastava

    HP ProCurve Switch 2824 NCM Backup

    alankar.srivastava

      Hello Everyone,

       

      I am facing NCM backup failure issue on HP devices . I created a new template below but after pressing 5 . it's automatic goes into status & counters option . On device the Option is 5 for entering into config mode(CLI) . Anyone help me on this how to enter into CLI option by passing the variable in template?

       

      <!--SolarWinds Network Management Tools-->

      <!--Copyright 2007 SolarWinds.Net All rights reserved-->

      <Configuration-Management Device="HP ProCurve Switch 2824" SystemOID="1.3.6.1.4.1.11.2.3.7.11.31">

      <Commands>

      <Command Name="RESET" Value="terminal length 1000"/>

      <Command Name="Reboot" Value="reset board{CRLF}y${CRLF}"/>

      <Command Name="EnterConfigMode" Value="configure t"/>

      <Command Name="ExitConfigMode" Value="end"/>

      <Command Name="Startup" Value="text-config-file"/>

      <Command Name="Running" Value="text-config-file"/>

      <Command Name="DownloadConfig" Value="Show running-Config"/>

      <Command Name="UploadConfig" Value="${EnterConfigMode}${CRLF}${ConfigText}${CRLF}${ExitConfigMode}"/>

      <Command Name="DownloadConfigIndirect" Value="copy config tftp text${CRLF}${StorageFilename}${CRLF}${StorageAddress}${CRLF}"/>

      <Command Name="UploadConfigIndirect" Value="copy tftp file${CRLF}4${CRLF}${StorageFilename}${CRLF}${StorageAddress}${CRLF}"/>

      <Command Name="EraseConfig" Value="reset configuration${CRLF}y${CRLF}"/>

      <Command Name="PreCommand" Value="X"/>

      <Command Name="PreCommand" Value="5"/>

       

                     <Command Name="Version" Value="show version"/>

                     

      </Commands>

      </Configuration-Management>