1 Reply Latest reply on Nov 29, 2016 9:16 AM by M33DLO

    NCM/Compliance- How to filter routers 'lower' than a Cisco 2951?

    M33DLO

      Hey guys!

       

      I have some configuration I need to rollout. But only to routers that are 295x or higher.

      On some of our lower specced sites (Cisco 1941 for example) the config (ip inspect audit-trail vrf) increases CPU to a high level that affects forwarding speed.

       

      Is this possible, or is it a manual process of sorting NCM nodes by 'machine type' and applying the config by Cisco variant. (this could take hours in our environment)

       

      Also add this to the mix: I only need these commands on a router that has the config below applied (indicating its an internet router):

      ip access-list extended ThisACL

       

      So I need to use NCM or the compliance manager to help me select the nodes that:

      • 2950 or higher
      • Has ThisACL applied.

       

      Can this be done? I assume by some clever regex on the compliance rule to find the device type?

      Any ideas on the correct regex to use?