This discussion has been locked. The information referenced herein may be inaccurate due to age, software updates, or external references.
You can no longer post new replies to this discussion. If you have a similar question you can start a new discussion in this forum.

IPAM scan completes but no results

I'm new to Solarwinds and getting things setup for the first time under a trial licence. I've added a subnet and scanning is enabled. The scan completes but returns no results and there is no obvious reason as to why. I receive the following alert "The scanning of '10.0.0.0 /19' started at 14/09/2016 16:04:52 has finished successfully. 0 IP(s) were found. The scan duration was '0' minutes."

Any suggestions on what the problem may be?

Thanks