This discussion has been locked. The information referenced herein may be inaccurate due to age, software updates, or external references.
You can no longer post new replies to this discussion. If you have a similar question you can start a new discussion in this forum.

Need assistance to add the below tunnels for monitoring.

Hi,

I was trying to add tunnels to monitoring. But I don't see resources to check it for monitoring. Please advise on how I can proceed with these to set these tunnels ge2/3/4/5 for monitoring.

PSA-PROD-7840-4:v10525> portshow fciptunnel all -c

Tunnel Circuit  OpStatus  Flags    Uptime  TxMBps  RxMBps ConnCnt CommRt Met/G
--------------------------------------------------------------------------------
24    -         Up      --i----a-    14d4h    0.00    0.01   2      -       -
24    0 ge2     Up      ----ah--4    14d4h    0.00    0.00   2   500/2000  0/-
24    1 ge3     Up      ----ah--4    14d4h    0.00    0.00   2   500/2000  0/-
24    2 ge4     Up      ----ah--4    14d4h    0.00    0.00   2   500/2000  0/-
24    3 ge5     Up      ----ah--4    14d4h    0.00    0.00   2   500/2000  0/-
--------------------------------------------------------------------------------
Flags (tunnel): i=IPSec f=Fastwrite T=TapePipelining F=FICON r=ReservedBW
                 a=FastDeflate d=Deflate D=AggrDeflate P=Protocol
                 I=IP-Ext
      (circuit): h=HA-Configured v=VLAN-Tagged p=PMTU 4=IPv4 6=IPv6
                 ARL a=Auto r=Reset s=StepDown t=TimedStepDown