This discussion has been locked. The information referenced herein may be inaccurate due to age, software updates, or external references.
You can no longer post new replies to this discussion. If you have a similar question you can start a new discussion in this forum.

SNMP v3 on Cisco v3

We have configured snmp v3 on cisco 2921 router and add nodes to solarwind as per Setup Cisco SNMPv3 via CLI.pdf guide(check attached), but we can't see router enviroment features e.g CPU utilization,serial number.

can you please help

  • do you enable the view (itr should be - because it is default-Setting.

    Your test is succesful?

    regards,

    Flo

  • FormerMember
    0 FormerMember

    if you haven't add this statement below (a) to the router or switch of course you have to modify the IP

    Note: This assumes that you have setup and configured SNMPv3 on the device already. 1. Add the following while in Configuration Terminal: a. Command: snmp-server host 10.10.1.6 version 3 auth TestSNMPv3User

    the document you have here is perfect that's what I used to configure snmpv3 successfully