This discussion has been locked. The information referenced herein may be inaccurate due to age, software updates, or external references.
You can no longer post new replies to this discussion. If you have a similar question you can start a new discussion in this forum.

Report using custom node poller getting Unable to complete transform error.

I have written a report using data I have collected via OiD in UnDP and is assigned for the nodes I want reported on.  When writing the report about 1/2 to 3/4 of the nodes report properly.  Then the rest I get the "Unable to complete transform. See KB article 4779 for possible reasons."  These nodes show the information on the summary page from the data pulled by UnDP for the node so it is polling the OiD properly, but for some reason in the report it is not returning the value.  Any help would be nice.